Modify your browser’s settings to allow Javascript to execute. Make sure fans are connected and working properly some fans only operate when needed. Network Server Mode is enabled in Computer Setup. Fluorescent lights or fans may be too close to the monitor. Blank screen and the power LED flashes Red six times, once every second, followed by a two second pause, and the computer beeps six times.

Uploader: Kagarr
Date Added: 23 September 2014
File Size: 60.81 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41987
Price: Free* [*Free Regsitration Required]

If the hard drive LED does not turn on green then:. Jack has been reconfigured in the audio driver or application software. Unable to access data on the media card after inserting it into a slot. Be sure that all the needed device drivers have been installed. Observe the beeps and LED agere system pci-sv92pp soft modem on the front of the computer. Network mdoem stopped working when an expansion board was added to the computer.

Power supply will not turn on because of internal power supply fault. When attempting to resume from standby agere system pci-sv92pp soft modem, do not hold down the power button for more than four seconds. Network controller is not set up properly. Full scheduling capabilities and daily scans. The brightness and contrast controls are not set properly. Drive not found identified.

Replace the system board. See the documentation that came with the optional device.

Power switch of new external device is not turned on. Check that the voltage selector, located on the rear of the power agede on some models, is set to the appropriate agere system pci-sv92pp soft modem. Update your software and prevent problems. Systek on System and Maintenance. Export and backup of complete software setups. Reseat the graphics card. Wake the computer by pressing any key on the keyboard or pressing the power button.

Remove the roller ball cover on the mouse and clean the internal components. Proper voltage setting depends on your region.

HP Compaq dc Business PC – Troubleshooting Without Diagnostics | HP® Customer Support

Sfot will not start. Program previously accessed did not release reserved memory back to the system. Be sure the monitor cable is securely connected to the computer. The media card is not inserted properly, is inserted in the wrong slot, or is not supported. For systems with integrated graphics, replace the system board. USB ports on the computer are disabled in Computer Setup. Make sure the correct network client and protocol is installed. The printer may be out of paper.

In the Tasks list, select Device Manager. Use the system volume control available in the operating system to make sure the speakers agere system pci-sv92pp soft modem not muted afere to increase the volume.

Download – UpdateStar – 01

If the printer works, reload the printer driver. Import complete software setups. From Windows Explorer select the agee A drive. Verify that the modem is connected and communicating properly. Replace the device that is causing the failure. Cursor will not move using the arrow keys on the keypad. Blank screen and the power LED flashes Agere system pci-sv92pp soft modem five times, once every second, followed by a two second pause, and the computer beeps five times.

Hard drive is damaged. Mouse roller ball or the rotating encoder shafts that make contact with the ball are dirty. Change the default drive letter for the flash drive in Windows.

Leave a Reply

Your email address will not be published. Required fields are marked *